18
Calder Brothers Corp
V 1.0
Model: 1860 Paver
SN:
Serial Number Range:
874-S-86TCX5Y2*03874 to _____________
3.11 Tow Point
There are two switches at each operators station. Left
switch (1) will adjust left hand tow point cylinder, and right
switch (2) will adjust right hand tow point cylinder.
The tow point cylinder (3) on each side adjust the angle of
the screed. Before starting to pave, verify cylinders are at
their midpoint so half the cylinder piston is exposed.
If equipped with the optional screed automation system,
these cylinders will be utilized by the automation system.
When operating with out the automation system, switches
(1) and (2) may be used in lieu of the manual screed depth
cranks.
3.12 Exhaust Aftertreatment Regeneration
Note: Refer to the engine OEM manual for important
safety, detailed operational and maintenance information
on the exhaust aftertreatment system.
The paver is equipped with a three position switch (1).
With switch in the up (inhibit) position, active cleaning of the
aftertreatment will not be allowed.
With switch in the center (neutral) position, neither the start
or inhibit functions are active. This position is recommended
for normal engine operation. The engine will automatically
regen when it needs it unless the inhibit is selected
With switch in the force position, this will force a regen
when the engine is not calling for it yet.
To Next Page
Loading...