39
Calder Brothers Corp
V 1.0
Serial Number Range:
874-S-86TCX5Y2*03874 to _____________
Model: 1860 Paver
6.6.2 Change Engine Oil And Oil Filter
1. See OEM engine operators manual for oil and lter
specications.
2. Fully open hopper doors.
3. Prepare paver for inspections and maintenance. See
Section 6.2 Prepare For Inspections And Maintenance.
4. Wear personal protective equipment appropriate for the
task.
5. Allow engine and surrounding parts to cool before
proceeding.
6. Position an adequate drain pan under plug (1).
7. Remove plug (1) to drain engine oil. Install plug after all
oil has drained.
8. Remove cover (2) to access engine oil lters.
9. Remove and discard existing oil lter.
10. Fill new lter with clean engine oil.
11. Lightly coat lter sealing ring with oil.
12. Install lter until seals contacts ange. Tighten an additional 1/2 - 3/4 turn by hand. Do not over tighten.
13. Fill crankcase to correct level.
14. Start engine and run at low idle.
15. Stop engine, remove key and attach a Do Not Operate tag or similar warning tag to ignition switch.
16. Check engine oil level and check for leaks.
17. Install cover (2).
18. Dispose of oil and lter in an environmentally safe manner.
6.7 Yearly / 500 Hours
6.7.1 Change Hydraulic Oil And Filters
1. Prepare paver for inspections and maintenance. See
Section 6.2 Prepare For Inspections And Maintenance.
2. Wear personal protective equipment appropriate for the
task.
3. Place catch pan under lter.
4. Remove and replace spin on lter (1) and lter (2).
5. Pump hydraulic oil out of reservoir ll cap with a transfer
pump.
6. Remove drain plug (A) and drain hydraulic oil into a
suitable container. Install plug after draining.
7. Add new hydraulic oil to reservoir until oil is visible in
sight glass (3).
8. Start engine and safely operate hydraulics. Stop
engine and check hydraulic oil level. Add hydraulic oil
if necessary.
9. Dispose of hydraulic oil in an environmentally safe manner.
To Next Page
Loading...