27
Calder Brothers Corp
V 1.0
Serial Number Range:
874-S-86TCX5Y2*03874 to _____________
Model: 1860 Paver
5. Screed Setup
5.1 Crown Setting
1. Start paver engine. See Section 3.4 Start Engine.
2. Toggle tow point switches (1) and (2) to expose an equal
amount of the cylinder rod on each cylinder.
3. Toggle screed switch (3) to lower screed onto a at
surface.
4. Rotate screed depth handles (4) until they are free and
not in tension.
^ WARNING
Crush hazard.
A raised screed may lower unexpectedly.
Engage screed support locks to support screed.
Do not place any part of body under screed.
5. Fully raise screed and engage support locks (5) as
shown on each side of paver.
6. Lower screed until screed arms are resting on support
locks.
To Next Page
Loading...