Mauldin 1860 - Prepare Paver for Inspections and Maintenance; Daily before Use; Check Engine Oil Level; Check Engine Coolant Level

34
Calder Brothers Corp
V 1.0
Model: 1860 Paver
SN:
Serial Number Range:
874-S-86TCX5Y2*03874 to _____________
6.2 Prepare Paver For Inspections And Maintenance
^ WARNING
Entanglement and crush hazard.
Keep all personnel clear of augers, conveyors and other rotating shafts when engine is running
or about to be started.
Verify all guards are in place.
Follow lockout/tagout procedure before performing inspections or maintenance.
Before performing inspections, service or maintenance:
• Park paver on rm level surface.
• Lower screed to ground or engage screed support locks.
• Fully open or close hoppers.
• Turn engine off and remove ignition key.
• Attach a Do Not Operate tag or similar warning tag to the ignition switch.
• Follow lockout/tag out procedure as dened by your company.
After performing inspections, service or maintenance, verify all guards have been reinstalled and all safety
devices are functional.
Wear personal protective equipment appropriate for the task.
Use Mauldin replacement parts.
6.3 Daily Before Use
6.3.1 Check Engine Oil Level
1. Prepare paver for inspections and maintenance. See Section 6.2 Prepare For Inspections And Maintenance.
2. Push dipstick down fully and pull out. If oil level is below add mark, add proper grade and viscosity of oil through
ller tube to raise oil level to full mark. Do not overll. Refer to engine OEM manual for oil specications.
6.3.2 Check Engine Coolant Level
^ WARNING
Hot pressurized liquid.
Burn hazard.
Do not remove cap when hot.
NOTICE
Do not add coolant to a hot engine. Engine can be damaged.
Check engine coolant level in sight glass. Coolant must be visible in sight glass. Add coolant if necessary. Refer
to OEM engine manufacturers’ manual for coolant specications.