Mauldin 1860 - Prime Fuel System; Paver Shutdown; Drive Disconnect

20
Calder Brothers Corp
V 1.0
Model: 1860 Paver
SN:
Serial Number Range:
874-S-86TCX5Y2*03874 to _____________
3.16 Prime Fuel System
If engine has run out of fuel, the fuel system will need to
be primed after refueling. Loosen primer (1) on fuel/water
separator and pump until resistance is felt. Tighten primer.
3.17 Paver Shutdown
1. Park paver on rm level surface.
2. Lower screed to ground.
3. Close hoppers.
4. Turn engine off and remove ignition key.
3.18 Drive Disconnect
If paver is disabled and must be towed to a safe location, use the following procedure to disengage paver drive.
1. Turn engine off, remove ignition key and place a Do Not
Operate tag on ignition switch.
2. Remove cap screw (1).
3. Loosen cap screw (2).
4. Rotate end cover (3) until large hole is over center of
hub and hole (4) is over threaded hole.