Setup
Prefab Cable Assemblies
EPOS4 Disk 60/8 Hardware Reference
3-40 CCMC | 2021-10 | rel10276
3.4 Prefab Cable Assemblies
Best practice
The actual connections you will need to establish depend on the overall configuration of your drive system,
the type of controller, and the type of motor you will be using. Check on
chapter “4 Wiring” on page 4-51
for the prefab cable assemblies you will actually require in your setup.
Table 3-50 Power & Motor Cable
Table 3-51 Hall Sensor Cable
Power & Motor Cable
(696283)
This cable fits
connectors…
X1/X2
X3
Type / length
3 x 1 mm
2
, shielded, grey / 3 m
Wire identifier Numbers 1 ¦¦ 2 ¦¦ 3
Head A
Plug Molex Micro-Fit (0436450300)
Contacts Molex Micro-Fit (0430300038)
Head B
Wire end sleeves 1 mm
2
Hall Sensor Cable
(696284)
This cable fits
connector…
X4
Type / length
5 x 0.14 mm
2
, shielded, grey / 3 m
Wire identifier Colors white ¦¦ brown ¦¦ green ¦¦ yellow ¦¦ grey
Head A
Plug Molex Micro-Lock (05055650501)
Contacts Molex Micro-Lock (05054311000)
Head B
Wire end sleeves 0.14 mm
2
To Next Page
Loading...