Maxon TE-15 - Page 30

11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713
30
7. Clamp both mounting plates to
vehicle frame. Weld the mount-
ing plates to vehicle frame as
shown in FIGS. 30-1 or 30-2.
Remove clamps.
MOUNTING
PLATE
TE-25 & TE-30
WELD TO VEHICLE FRAME (RH SIDE SHOWN)
FIG. 30-2
2” LG. 4 PLACES
(TYPICAL - RH & LH
MOUNTING
PLATES)
1/4”
VEHICLE FRAME
(TYPICAL TRUCK
FRAME SHOWN)
BOLTS
(4 PLACES)
CUT LINE & TOP WELD
(IF NECESSARY)
1/2”
6. If necessary, unbolt mounting
plate to cut at the top as shown
in FIGS. 30-1 or 30-2. Repeat
for LH mounting plate. Then,
bolt mounting plates in correct
positon. Torque mounting plate
nuts and bolts 220 - 240 lb-ft.
STEP 2 - WELD LIFTGATE TO VEHICLE - Continued
MOUNTING
PLATE
TE-15 & TE-20
WELD TO VEHICLE FRAME (RH SIDE SHOWN)
FIG. 30-1
2” LG. 4 PLACES
(TYPICAL - RH & LH
MOUNTING
PLATES)
1/4”
VEHICLE FRAME
(TYPICAL TRUCK
FRAME SHOWN)
BOLTS
(4 PLACES)
CUT LINE & TOP WELD
(IF NECESSARY)
1/2”