Maxon TE-15 - Page 29

11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713
29
STEP 2 - WELD LIFTGATE TO VEHICLE - Continued
NOTE: For painted Liftgates, weld both mounting plates to vehicle frame before fully
welding mounting plates to painted main frame.
TE-25 & TE-30
WELD TO VEHICLE FRAME AND MAIN FRAME
(RH SIDE SHOWN)
FIG. 29-2
2” LG. 4 PLACES
(TYPICAL - RH & LH
MOUNTING
PLATES)
1/4”
VEHICLE FRAME
(TYPICAL TRUCK
FRAME SHOWN)
5. Clamp both mounting plates to ve-
hicle frame. Weld the mounting plates
to vehicle frame as shown in FIGS.
29-1 or 29-2. Remove clamps.
MOUNTING
PLATE
TE-15 & TE-20
WELD TO VEHICLE FRAME
(RH SIDE SHOWN)
FIG. 29-1
2” LG. 4 PLACES
(TYPICAL - RH & LH
MOUNTING
PLATES)
1/4”
VEHICLE FRAME
(TYPICAL TRUCK
FRAME SHOWN)
MOUNTING
PLATE