11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713
60
STEP 12 - PLATFORM ADJUSTMENT (IF REQUIRED)
- Continued
“B”
(TABLE 60-1)
TIP OF FLIPOVER DOES
NOT TOUCH GROUND
FIG. 60-1
4. Make sure platform is still at ground
level. If the tip of fl ipover is not touching
the ground, measure and compare dis-
tance “B” (FIG. 60-1) with TABLE 60-1
to determine how much to grind from the
platform stops (FIG. 60-2).
6. Raise the platform, then lower it to the
ground. As the platform fi rst touches the
ground, the tip of fl ipover and shackle
should touch at the same time as shown
in FIG. 60-3.
TIP OF
FLIPOVER
GRINDING PLATFORM STOPS
(RH SHACKLE SHOWN)
FIG. 60-2
SHACKLE
(REF)
PLATFORM
STOP
GRIND ENTIRE
SURFACE HERE
(TABLE 60-1)
LOWER TIP OF
FLIPOVER
THIS DISTANCE “B”
GRIND METAL FROM
PLATFORM STOP
9/16” 1/16”
1-1/4” 1/8”
1-15/16” 3/16”
2-5/8” 1/4”
GRIND TO LOWER TIP
TABLE 60-1
5. Grind correct amount of metal (TABLE
60-1) from platform stop as shown in
FIG. 60-2.
PLATFORM & SHACKLES
TOUCH GROUND
FIG. 60-3
TIP OF
FLIPOVER
SHACKLE
To Next Page
Loading...
