Reciprocating Compressor M Series
1-2
z An example of Material Safety Data Sheet (MSDS) is provided as a reference at the end of
this chapter.
1.1.1.6 Do's about Handling Emergency Situation
z Formulate an emergency action plan complying with the regulations. Post it in a place where the
workers can always see it.
1.1.1.7 Do's about Waste Oil, Fluid, and Materials
z Disposing of refrigerant and oil used for the compressor are subject to a number of regulations for the
environmental protection purposes. Follow the local, state, federal acts and regulations and your
company's rules when disposing of such waste oil, fluid and materials.
1.1.1.8 Other Do's
z Keep the floor clean around the refrigerating, cold storage, and air conditioning systems, and keep
passages and walkways clear.
z Walk only on the areas set up as a work floor. Also, do not leave tools and cleaning solutions in that
area.
z If water or oil is spilled on the compressor or the floor, immediately wipe it off to prevent workers
from injury.
1.1.2 Don'ts
z Do not remove or relocate any safety device, including electrical interfaces.
z Do not disable any safety device by short-circuiting or bypassing without any permission.
z Do not leave the compressor unsafe and unattended, by removing a safety cover or some other
measures.
z Do not touch, clean, or lubricate any moving part of the compressor during the operation.
z Do not touch relays or electric systems such as terminal block with bare hands when turning on the
power.
To Next Page
Loading...
