MAYEKAWA 4M - Seal Cover Assembly and Bellows Oil Sleeve Removal

Reciprocating Compressor M Series
5-42
5.5.13 Seal Cover Assembly
Steps Description
Part
No.
Steps Description
Part
No.
1
Shower flushing sleeve
41-1 3
Mechanical seal mating ring
32
(Refer to "Removing the bellows oil
sleeve".)
(Refer to "Assembly of the Mechanical
Seal Mating Ring".)
(Refer to "Assembly the bellows oil
Sleeve".)
4
"O"ring, mechanical seal mating ring
42
2
"O"ring, bellows oil sleeve
41-2 5
Plug (R1/4 orifice ij3)
P-1
6
Shaft seal cover
26
1. Remove the parts in the order shown in the figure.
2. Attach the parts in the reverse order of removal.
5.5.13.1 Attentions for Removing the Bellows oil Sleeve
1. Loosen the bellows oil sleeve locking screw.
2. Attach the two bolts (M6) into the bolt holes on
the bellows oil sleeve.
3. Pull out the bolts (M6) to remove the bellows oil
sleeve.