Maytronics M600 - Using the Robotic Pool Cleaner; Setup Procedure

M600 Disassembly Instructions
Disassembling the M600 4
Disassembling the M600
The following steps describe how to disassemble the M600.
1.
Open the filter cover, grasp the filter handle, and pull the filter upward to remove it.
Note: The filter handle springs up when you open the filter cover.
Figure 1: Opening the filter cover and removing the filter
2.
Tilt the cover to an angle as shown below and then pull the pins of the filter cover
one after the other.
Note - Usage of a screw driver to open
Figure 2: Removing the filter cover