Body & Accessories Accessories
Seat Position Memory
• Three seat positions can be programmed in the position memory control module
corresponding to the memory switch.
• An additional seat position can be programmed corresponding to each transmitter.
• Programming of the seat position is possible according to the following procedures.
Seat Position Programming Using the Memory Switches
1. Slide the seat manually to the desired position.
2. Press and hold the set switch. Then press one of the memory switches 1, 2, or 3.
3. Buzzer sounds and the seat position is programmed.
Seat Position Programming Using the Transmitter
1. Slide the seat manually to the desired position.
2. Press and hold the set switch. Then press the UNLOCK button on the transmitter.
3. Buzzer sounds and seat position is programmed.
NOTE: If the vehicle battery is disconnected for more than 5s, all of the seat position
memory will be erased.
Seat Positioning Using Memory Switch
• If all of the following conditions are met, the seat position is automatically called up by
the memory switch operation.
– Door is open (door switch on).
– Seat position has been programmed.
– Ignition switch is in the LOCK position.
– Vehicle is stopped (vehicle speed 2 km/h [1.24 mph] or less).
Seat Positioning Using Transmitter
• When the door is opened within approx. 2 s after it is unlocked using the transmitter, the
auto call up operation slides the seat to the programmed position.
Service Training Mazda6 Facelift 09-17
To Next Page
