108
5.10 Machine Inspection Record
McCONNEL
MACHINE INSPECTION
RECORD
(For SR460/620/820)
Pre-delivery inspection:
Select
Installation inspection:
Select
Daily pre-work inspection:
Select
Model:
Serial No:
Inspector name (print):
Inspection date:
Company/Position:
Inspector signature:
Check that an operator’s instruction manual in the correct language
for the working territory is in the machine document holder.
Check that the operator’s instruction manual is filled in and serial
number is present and matches the serial number of the machine.
Warning decals are present, clean and in good order
Inspect main fabrications and damage – decks, axles, drawbar e.t.c.
Inspect all hosing for damage – kinks, twists chafing or weeping
Ensure hydraulic hoses are routed to tractor through the hose guide
Inspect all hydraulic rams for damage and oil leaks
Inspect all hydraulic ram breathers are present
Inspect all lighting on the machine to ensure it is operating correctly
Inspect to see all warning decals are present, legible and clean
Inspect PTO shaft and cone guards for integrity and condition
Inspect to see all protection chains are present
Inspect to see all fixed guarding protection is present
Inspect each axle rubber cushion on each axle are in good condition
and giving sufficient suspension and ride cushioning
Ensure when fitting the machine to the tractor that a wear pad is
placed between the towing eye and hitch of the tractor
Ensure when fitting the machine to the tractor that the safety chain
is fitted between the tractor and drawbar
Inspect blade condition against the operator’s manual guidance
Inspect that the correct blades are fitted for the given rotor direction
against the operator’s manual
Inspect blade carrier anti-scalp dish condition against the operator’s
manual guidance
Check all hydraulic hoses and adaptors for tightness and tighten to
the correct torque setting given in the operator’s instruction manual
Ensure the oil gearbox quantity is to the level mark on each
gearbox. Consult the maintenance schedule to see whether an oil
change is scheduled
Ensure the gearbox breather are present and free from dirt
Check the gearbox mounting fasteners are tight to the correct
torque setting given in the operator’s instruction manual
Check the axle clamp fasteners are tight to the correct torque setting
given in the operator’s instruction manual
Check the axle fasteners are tight to the correct torque setting given
in the operator’s instruction manual
Randomly test for loose nuts and bolts. Tighten to manual settings
Check all clutch settings against operator’s manual values
Check driveshaft retaining bolts torque setting against operator’s
manual values
Grease all grease points in accordance with the operator’s manual
To Next Page
Loading...
