29
2.9.1 Disposal
When McConnel equipment reaches the end of its economic working life it should be disposed of responsibly,
either through an approved recycling centre or by compliance with all regulations in force in the destination
territory.
In most instances McConnel machines can be broken into its constituent parts with the use of basic workshop
equipment. Table contains a typical list of constituent materials, together with disposal guidelines.
When undertaking a machine breakdown, take care to ensure that heavy parts are always adequately supported
to avoid injury.
To avoid environmental contamination, take containment precautions to retain control of liquids in order.
It is the owner’s responsibility to ensure the machine is disposed of in accordance with all applicable regulations.
Material Typically found in; Disposal guideline
Steel Structural components, fixed guards,
fasteners and driveline
Can be dismantled and recycled. Take care
when handling heavy and/or sharp objects
Aluminium Pump and gearbox housings, serial
number plates
Can be dismantled and recycled. Take care
when handling heavy and/or sharp objects. Take
appropriate actions for oil contaminated products
Copper Wiring, electrical components Can be recycled using appropriate recovery
procedures.
Hydraulic oil Tank, hydraulic components Dispose of in accordance with all applicable
regulations
Rubber Hoses, flexible guards, seals, ‘O’ rings Dispose of in accordance with all applicable
regulations
Plastics Clips, caps, cable ties, decals, filter
housings, document holders, bushes,
electrical components, plugs, connectors,
wire insulation
Dispose of in accordance with all applicable
regulations
Filter element Filter housings Dispose of in accordance with all applicable
regulations
Cork / paper Gaskets Dispose of in accordance with all applicable
regulations
Table 2.5 – Machine Breakdown Component Disposal
To Next Page
Loading...
