65
Never tow the machine behind a truck or other type of vehicle. Never tow two machines behind each
other in tandem. Never tow the machine at speeds over 20 mph (32 kmh).
DANGER! Never allow children or other persons to ride on the tractor or machine. Falling off can result
in serious injury or death.
4.12.1 Transport Width Adjustment (SR460 only)
Equipment Required
36mm hex spanner
NOTE: Only applicable to SR460
The screw adjustment on the wing ram mounting point enables the transport width to be minimised when the
wings are raised. Ensure wing rams are pressurised and fully closed before lengthening adjusting bolt to reduce
transport width.
Figure 4.39 – SR460 Wing Transport Width Adjustment
In order to reduce the width of the machine, loosen out the bolt from the wing float bracket; see Figure 4.39. The
machine should already be set up correctly to give a correct transportation width.
4.12.2 Marker Boards (SR460 only)
Before proceeding to take the SR460, rotate the marker boards out so that the marker boards are the widest
point on the machine.
Figure 4.40 – SR460 Marker Board Rotation
To Next Page
Loading...