110
5.11 Machine Storage
Follow the sections below for guidance to correctly storing SR460/620/820 machines out of working use and
preparing back into correct working condition.
5.11.1 Preparing the Machine for Storage
Following seasonal use it is important to prepare the machine for storage, thinking of the preservation of parts
condition and ease of reintroduction when bringing the machine back into work after periods of no use.
Follow the following points:
5.11.1.1 Thoroughly wash the machine removing all traces of grass and dirt.
Great care should be taken when using pressure washers. Do not hold the
pressure washer lance close to the paintwork and items containing seals as this can
cause damage and discolouration.
McConnel does not recommend using steam cleaners.
5.11.1.2 Unload the spring tension out of slip clutch assembly to free the clutch plates, to
ensure they do not seize.
At this point check the condition of the friction plates, if there is any sign of
overheating, wear or cracking; replace with new.
5.11.1.3 Remove and store the input PTO shaft and splitter/centre rotor gearbox coupling.
5.11.1.4 Inflate tyres (including wing tyres) to the correct pressure as stated in Section 5.7.1.
5.11.1.5 Grease all grease points following the guidance given in Section 5.2.3 and 5.2.4.
5.11.1.6 Liberally place oil along the complete length of each of the wing hinges.
5.11.1.7 Liberally smear grease along the length of exposed plated hydraulic ram shafts and
any other exposed threaded item.
5.11.1.8 Tighten all fasteners, pins and hoses to the recommended torque.
5.11.1.9 Use touch up paint available from McConnel where necessary to preserve the
appearance of the machine.
5.11.1.10 Ideally store the machine in the dry indoors, on a firm surface or stands, away from
the elements. This will greatly preserve the machines physical appearance and
condition.
It is also best practice to inspect the machine for worn/damaged items which will be required
to be replaced before entering work again in the new season. Consult the maintenance
schedule for the machine (Section 5.10) as well as other specific maintenance task sections to
see what could be required to be done to the machine.
Ordering replacement parts at the beginning of this period with plenty of time will potentially
reduce the delays of reintroduction into work with out of stock items. Many other local
operators will be carrying out the same procedure at the same time.
Figure 5.78 – Prepare for Storage
Where parts are broken, damaged and deemed not fit for use; replace with genuine McConnel parts using the
online Interactive Parts facility at:
https://my.mcconnel.com/parts/public-interactive-parts-database/
You will require the machine serial number. Assistance to its location can be found in Section 1.3.
To Next Page
