2
1.2 General Arrangement
The layout and naming convention used throughout this manual for each of the machines are shown in the table
below. The numbering and positioning of the relevant item can be found for the particular machine in Section
1.2.1 for the SR460, Section, Section 1.2.2 for the SR620 and Section 1.2.3 for the SR820.
1 Centre Deck 16 Walking Axle Wheel Bogie
2 Left-hand Wing Deck 17 Jack
3 Right-hand Wing Deck 18 Stand
4 Axle 19 Splitter Gearbox Guard
5 Walking Axle 20 Centre Lift Ram
6 Left-hand Wing Axle 21 Wing Lift Ram
7 Right-hand Wing Axle 22 Tie Bar
8 Left-hand Walking Wing Axle 23 Towing Eye
9 Right-hand Walking Wing Axle 24 Drawbar
10 Splitter Gearbox 25 Lifting Blade
11 Gearbox 26 Anti-scalp Dish
12 Centre Coupling 27 Skid
13 PTO (Power Take-Off) With Overrun 28 Chain Guard
14 Height Adjuster 29 Wheel Arm
15 Wing Adjuster 30 Wing PTO Shaft
Table 1.1 – SR460/620/820 Machine Components
To Next Page
Loading...
