18
machine and reduce hazardous risks to operator and bystanders before the final cutting
height is achieved.
2.3.5.14 WARNING! Avoid mowing in reverse with the PTO engaged. Disengage the mower and raise
the machine then reverse. Then lower the machine, engage PTO and drive forward again.
2.3.5.15 WARNING! Avoid turning sharply with the machine or lifting the machine which cause the
driveline to “knock”.
2.3.5.16 CAUTION! Splitter and rotor gearboxes can become very hot when in work. Ensure that the
gearbox is sufficiently cool before going anywhere near a gearbox.
2.3.5.17 CAUTION! Ensure that the decks of the machine are clear of excess debris. Splitter and rotor
gearboxes and other driveline components can become hugely hot when in work and debris
could cause risk of a fire hazard.
2.3.5.18 IMPORTANT: Ensure that a suitable fire extinguisher is carried inside the tractor at all times.
2.3.5.19 WARNING! Pay special attention when working with the machine and do not allow the
machine to touch fixed objects such as road drains, walls, shafts, curbs, guard rails, tracks etc.
as these could break the blades which could cause debris to be thrown at very high speed from
the machine. A fire hazard could be created in contacting objects as well. As a precaution raise
the cutting height of the machine to ensure they do not collide when the machine is in work.
2.3.5.20 DANGER! Avoid wire. It can be extremely dangerous if wire catches in the rotor, and every
care must be taken to ensure this will not happen. Inspect the working area before
commencing.
2.3.5.21 WARNING! Check all key components including blades, blade carriers and anti-scalp
dishes.Blades can fail from impact and objects can be thrown at great velocity. Inspect and
replace all damaged components with genuine McConnel parts and ensure the machine is
running correctly again before resuming cutting operations.
Stop mowing immediately if blades strike a foreign object.
2.3.5.22 WARNING! Do not mow in standing water to avoid possible blade failure.
2.3.5.23 IMPORTANT: Stop and do not use the machine when there is vibration in the machine, as this
may cause breakage and extended serious damage. Find the cause of the vibration or have it
inspected by your local McConnel dealer and do not use the machine until the cause is
identified and eliminated.
2.3.5.24 IMPORTANT: During work you may be required to adjust your mowing speed to compensate
for changes in terrain such as slopes, grass type and density and depending on the cut height
you desire to achieve. You should also adjust your speed to compensate for external factors
such as overhead obstructions and debris/foreign objects.
2.3.5.25 WARNING! Failure to have sufficient load over the front axle (20% +) or to drive at
inappropriate speeds on undulating terrain may result in a loss of directional control.
2.3.5.26 CAUTION! Personnel should take regular breaks during work to minimise fatigue and ensure
alertness in work.
2.3.5.27 WARNING! While the tractor is running all personnel should keep well clear of the area around
the machine (90m/300 ft+) as there are numerous crushing, shearing, impact dangers caused
by the machine operation.
2.3.5.28 WARNING! During work, if the tractor requires refuelling ensure the machine is stopped and
the PTO is disengaged, the tractor engine is stopped and it’s handbrake is applied and ignition
key is removed.
To Next Page
Loading...
