17
McIntosh MVP851 DVD
Monitor/TV
How to Connect Video Components
How to Connect Video Components
Composite, S-Video and Component Video Signals can be
connected to and selected by the MHT200. The built-in On
Screen Operating Status and Setup Information is available
at the Composite and S-Video Monitor Outputs for Zone A.
Connect all of the available Source Video Outputs (Com-
ponent, S-Video and Composite) to the MHT200.
1. Connect video cables from the MHT200 DVD VIDEO
INPUTS to the McIntosh Video Outputs of the
MVP851 DVD Player.
2. Connect video cables from the MHT200 COMPO-
NENT VIDEO 2 INputs to the McIntosh Component
Video Outputs of the MVP851 DVD Player.
3. Connect video cables from the MHT200 SAT VIDEO
INPUTS to the Video Outputs of a Satellite Receiver.
4. Connect video cables from the MHT200 COMPO-
NENT VIDEO 1 INputs to the Video Outputs of a Sat-
ellite Receiver.
5. Connect video cables from the MHT200 VCR1 IN-
PUTS to the VCR Video Outputs.
Satellite Receiver
To AC
Outlet
6. Connect video cables from the MHT200 VCR1 OUT-
PUTS to the VCR Video Inputs.
7. Connect video cables from the MHT200 COMPO-
NENT Video, S-Video and Composite Video OUT-
PUTS to the Monitor/TV Component Video Inputs.
Note: If the Monitor/TV does not have Component Video
Inputs, then connect the MHT200 MON A S-Video or
Composite Output(s) instead.
8. Connect the MHT200 to a live AC Outlet.
Note: If the Zone B is to be connected, proceed to the next
page and DO NOT connect the MHT200 to a live AC
Outlet at this time.
VCROutIn
www.eskonline.nl
To Next Page
Loading...
