McIntosh MHT200

32
Location Default Setting New Setting
Left Front 10
Center 10
Right Front 10
Right Surround 10
Right Back none
Left Back
10
Left Surround
10
Subwoofer
10
Loudspeaker Manual Time Delay
or Right directional push-buttons to change the cur-
rent setting. When all of the settings on the SPEAKER
TIME DELAY MENU agree with the Loudspeakers
measured distances in your Home Theater System, se-
lect EXIT on the menu. The MAIN SYSTEM SETUP
Menu will reappear on the Monitor/TV screen.
Note: In the unlikely event that one or more of the
Loudspeaker’s measured distance is 15 feet greater
than any of the other Loudspeaker’s distances and
the number is entered, the On-Screen Display for
that channel will change from white to pink. This is
an indication the amount of electronic time delay
required to correct for the distances will not
produce the proper sonic results. Reposition one or
more of the Loudspeakers and then enter the new
settings.
6. Select the appropriate Loudspeaker location by using
the Up or Down directional push-buttons to select
first the menu item and then press the Left or Right
directional push-buttons to change the current setting.
When all of the settings on the SPEAKER TIME DE-
LAY MENU agree with the Loudspeakers in the Sys-
tem, select EXIT on the menu. The SPEAKER SETUP
Menu will reappear on the Monitor/TV screen.
7. Continue next to the SUBWOOFER SETTINGS. If you
do not wish to perform SUBWOOFER SETTINGS ad-
justments at this time, proceed to the next step.
8. Select EXIT from the SPEAKER SETUP Menu. The
MAIN SETUP Menu will reappear on the Monitor/TV
screen and select EXIT from the Menu. If you are satis-
fied with the changes that you may have made, select
YES to save those changes or NO not to save them.
The MHT200 will then return to normal operation. Re-
fer to figure 13 on page 25.
Figure 23
MENU: SPEAKER SETUP
1. SPEAKER SIZE
2. SPEAKER TIME DELAY
3. SPEAKER LEVEL
4. SUBWOOFER SETTINGS
5. AUTOCALIBRATE LEVELS
6. AUTOCALIBRATE DELAYS
EXIT
Automatic Time Delay Calibration
1. Remove the McIntosh Calibration Microphone, battery,
hook-up cable and microphone stand adapter from the
shipping carton.
Note: If the Automatic Speaker Level was previously
performed using the supplied microphone, proceed
to step 4.
2. Install the supplied AA 1.5V battery into the micro-
phone. This can be accomplished by rotating the large
Figure 24
Autocalibrating
Please wait
Acoustic speaker dist.
Calibrating: Left
Speaker dist.: 2.5ms
complete: 1/3
Press MENU to
abort autocalibration
www.eskonline.nl