44
How to Reset the MHT200
If it should become necessary to reset the MHT200 to the
Default Settings, follow the procedure below:
Notes: 1. First, if you are experiencing difficulties in operating
the MHT200, place the POWER ON/OFF in the OFF
Position for 5 minutes and then place it in the ON
Position. Turn-On the MHT200 using the STANDBY/
ON Push-button.
2. If the above step doesn’t return the MHT200 to normal
operation then call your Dealer for assistance or
McIntosh Technical Support.
3. Returning the MHT200 to Default Setup Settings
should be a last resort, not the first.
4. If possible, first write down any current Setup Settings
and Tuner Presets before proceeding, as all settings
will be returned to factory default condition.
Press the POWER switch to ON, the Red LED above the
STANDBY/ON Push-button lights to indicate the MHT200
is in Standby mode. Press the STANDBY/ON Push-button,
then immediately press and hold in the SETUP Push-button
before the title of MHT200 appears on the Front Panel Al-
phanumeric Display. When the Front Panel Alphanumeric
Display indicates SET DEFAULTS, release the SETUP
Push-button.
Note: The Video Format will return to North American Settings.
If the MHT200 is used outside of North America and
requires different settings, refer to System Setup on the
previous page.
www.eskonline.nl
To Next Page
Loading...
