McIntosh MHT200

57
Power Amplifer and General Specifications
General Specifications
Power Requirements
100 Volts, 50/60Hz at 8.4 Amps
110 Volts, 50/60Hz at 7.7 Amps
120 Volts, 50/60Hz at 7.0 Amps
220 Volts, 50/60Hz at 3.5 Amps
230 Volts, 50/60Hz at 3.5 Amps
240 Volts, 50/60Hz at 3.5 Amps
Note: Refer to the rear panel of the MHT200 for the correct
voltage.
Dimensions
Front Panel: 17-3/4 inches (45.09cm) wide, 9-7/16 inches
(23.97cm) high. Depth behind front mounting panel is 19
inches (48.26cm) including clearance for connectors. Panel
clearance required in front of mounting panel is 1-1/8
inches (2.9cm).
Weight
73 pounds (33.1Kg) net, 87 pounds (39.5Kg) shipping
Power Output with Rated Power Band
Minimum sine wave continuous average power output per
channel for Zone A, with specified number of channels op-
erating is:
Rated Power Band (80Hz to 20,000Hz) into a 4 ohm load
2 x 160 watts
3 x 140 watts
5 x 130 watts
6 x 120 watts
Rated Power Band (80Hz to 20,000Hz) into a 8 ohm load
2 x 100 watts
3 x 95 watts
5 x 85 watts
6 x 80 watts
Rated Power Band (20Hz to 20,000Hz) into a 4 ohm load
2 x 150 watts
6 x 100 watts
Rated Power Band (20Hz to 20,000Hz) into a 8 ohm load
2 x 95 watts
6 x 75 watts
Minimum sine wave continuous average power output per
channel for
Zone B, with both channels operating is:
Rated Power Band (20Hz to 20,000Hz) into a 4 ohm load
2 x 150 watts
Rated Power Band (20Hz to 20,000Hz) into a 8 ohm load
2 x 95 watts into a 8 ohm load
Total Harmonic Distortion
Maximum Total Harmonic Distortion at any power
level from 250 milliwatts to rated power output is:
0.05% for 4 or 8 ohm load
Dynamic Headroom
1.8dB
Frequency Response
+0, -0.25dB from 20Hz to 20,000Hz
+0, -3dB from 10Hz to 100,000Hz
Sensitivity
1.0 Volt
Power Amplifer Specifications
A-Weighted Signal To Noise Ratio
92dB (112dB below rated output)
Intermodulation Distortion
Maximum Intermodulation Distortion if instanta-
neous peak output per channel does not exceed
twice the rated output, for any combination of fre-
quencies from 20Hz to 20,000Hz, with the speci-
fied number of channels operating is:
0.05% for 4 or 8 ohm loads
Input Impedance
20,000 ohms
Wide Band Damping Factor
100 at 4 ohms
200 at 8 ohms
www.eskonline.nl