McIntosh MHT200

37
Digital Input
There are three Optical Digital Inputs and three Coaxial
Digital Inputs available for assignment with any of the
seven Analog Audio Inputs. The following example de-
scribes how to reassign Digital Input A, which by default
has been assigned to AUX Input, over to VCR2.
8. Using the Up or Down directional push-buttons
select SOURCE INPUT from the On-Screen Menu,
followed by pressing the Left or Right directional
push-buttons to select the AUX Input, Number 1. Refer
to figure 31.
9. Using the Up or Down directional push-buttons
select DIGITAL INPUT on the On-Screen Menu, fol-
lowed by pressing the Left or Right directional
push-buttons to select OFF.
Note: The default setting for the AUX Digital Input is
OPTical A.
10. Using the Up or Down directional push-buttons
select SOURCE INPUT from the On-Screen Menu,
followed by pressing the Left or Right directional
push-buttons to select the VCR2 Input.
11. Using the Up or Down directional push-buttons
select DIGITAL INPUT on the On-Screen Menu, fol-
lowed by pressing the Left or Right directional
push-buttons to select OPTical A.
Note: The default setting for the VCR2 Digital Input is
OFF.
Component Input
The MHT200 has Electronic Input Switching for two Com-
ponent Video Sources. The default assignments for the two
SETUP, con’t
Figure 32
MENU: SOURCE SETTINGS
1. SOURCE INPUT 6
2. TITLE VCR1
3. DIGITAL INPUT Opt C
4. COMPONENT INPUT 1
5. INPUT LEVEL
6. TRIM PRESETS No Change
7. TRIM PRESET SETUP
EXIT
inputs can be changed to match up with the two Component
Video Sources in the system. The following example de-
scribes how to reassign COMPONENT 1 IN Video Input,
which by default has been assigned to SAT Input, over to
the VCR1 Input instead. Refer to figure 32.
12. Using the Up or Down directional push-buttons
select SOURCE INPUT from the On-Screen Menu, fol-
lowed by pressing the Left or Right directional
push-buttons to select the SAT Input, Number 3.
13. Using the Up or Down directional push-buttons
select COMPONENT INPUT on the On-Screen Menu,
followed by pressing the Left or Right directional
push-buttons to select OFF.
14. Using the Up or Down directional push-buttons
select SOURCE INPUT from the On-Screen Menu, fol-
lowed by pressing the Left or Right directional
push-buttons to select the VCR2 Input.
15. Using the Up or Down directional push-buttons
select COMPONENT INPUT on the On-Screen Menu,
followed by pressing the Left or Right directional
push-buttons to select Number 1.
Input Level
Analog Audio Source components can have slightly differ-
ent volume levels. This could result in the constant need to
re-adjust the MHT200 Volume Control when switching be-
tween different Program Sources. A volume input level fea-
ture on the MHT200 allows for the adjustment of the levels
Figure 31
MENU: SOURCE SETTINGS
1. SOURCE INPUT 7
2. TITLE VCR2
3. DIGITAL INPUT Opt A
4. COMPONENT INPUT 1
5. INPUT LEVEL
6. TRIM PRESETS No Change
7. TRIM PRESET SETUP
EXIT
www.eskonline.nl