McIntosh MHT200

38
for various inputs so that they have the same relative vol-
ume. The Default Volume Level Setting for all Inputs is
0dB and each input has a range of adjustment in Volume
Level from +10dB to -5dB. The Tuner is usually a fre-
quently listened to source and makes a good reference for
comparing the volume between different inputs. It is help-
ful to note first, before beginning the adjustments, which
inputs have volume levels that are louder or quieter than
the Tuner Input. In the example below, the audio from the
AUX Input Source is louder than the sound from the Tuner
Input. The On-Screen Input Level Monitor displays (Elec-
tronic VU Meter) the actual Volume Level of the selected
input in real time. Refer to figures 33 and 34.
Note: The Input Trim Level Adjustment only affects Audio
Source Components connected to the Left and Right
Analog Inputs. There is no effect on the volume levels
from Digital Audio Sources Components connected to
one of the Digital Inputs. The Record Output Levels are
unaffected by any changes in the Input Trim Setting.
16. Using the Up or Down directional push-buttons
select SOURCE INPUT from the On-Screen Menu,
followed by pressing the Left or Right directional
push-buttons to select the AUX Input, Number 1.
17. Using the Up or Down directional push-buttons
select INPUT LEVEL on the On-Screen Menu, fol-
lowed by pressing the SELECT push-buttons.
18. Using the Left or Right directional Push-buttons
select -3dB for the new INPUT LEVEL.
19. Press the SELECT Push-button to enter the new Input
Level for the AUX Input.
20. Using the Up or Down directional push-buttons
select SOURCE INPUT from the On-Screen Menu,
followed by pressing the Left or Right directional
push-buttons to select the TUNER Input, Number 8.
Compare the the Tuner Volume Level to the new AUX
Input Volume Level.
21. If the AUX Input Volume Level is still louder than the
Tuner, repeat steps 16 through 20. When the volume
level on the AUX Input is about the same as the Tuner
Input, perform the Input Trim Adjustments for any
other Inputs that are quieter or louder than the Tuner.
Trim Preset Setup
The MHT200 allows the storing of up to five Trim Select
Presets into memory and assigning them to different
Source Inputs. Every time a given Source Input is selected
the Preset Trim Settings will be applied to that input, even
if the Trim Settings were changed using the Front Panel
Control the last time the Input was selected. Refer to figure
35.
Figure 33
MENU: SOURCE SETTINGS
1. SOURCE INPUT 6
2. TITLE VCR1
3. DIGITAL INPUT Opt C
4. COMPONENT INPUT 1
5. INPUT LEVEL
6. TRIM PRESETS No Change
7. TRIM PRESET SETUP
EXIT
Figure 34
Input level
monitoring 0
-2
Gain: 0dB -4
Peak: -7dB -6
press  or  -8
to change -10
sensitivity -12
Press SELECT -16
to accept -20
the changes dBr
22. Using the Up or Down directional push-buttons
select SOURCE INPUT from the On-Screen Menu,
followed by pressing the Left or Right directional
push-buttons to select the DVD Input, Number 5.
23. Using the Up or Down directional push-buttons
select TRIM PRESET SETUP on the On-Screen
Menu, followed by pressing the SELECT push-but-
tons.
24. Using the Left or Right directional push-buttons
www.eskonline.nl