34
YES to save those changes or NO not to save them.
The MHT200 will then return to normal operation. Re-
fer to figure 13 on page 25.
Dolby LFE Level
The Digital Processing Circuitry in the MHT200 allows for
a reduction in the overall low frequency output level of the
Home Theater System. This desired reduction may be as a
result of the Loudspeakers in the systems, the average low
frequency level found in the program sources, room acous-
tics and/or the need not to disturb person(s) that are nearby
the Home Theater Listening Room. The default setting for
the DD (Dolby Digital) LFE (Low Frequency Effect)
LEVEL setting is 0db and is the correct setting for most
Home Theater Systems. Refer to figure 27 and perform the
following steps to change the setting.
Note: If the overall low frequency output level is reduced by
using the DD LFE LEVEL Adjustment and certain
program source materials appear to be deficient in
low frequency output, they can be increased by using
the MHT200 Subwoofer Trim Level Control on the
Front Panel or Remote Control.
9. Using the Up or Down directional push-buttons
select DD LFE LEVEL from the On-Screen Menu, fol-
lowed by pressing the Left directional push-button to
reduce the level. The Right directional push-button
increases the level back towards 0dB. Select EXIT on
the menu and the SPEAKER SETUP Menu will reap-
pear on the Monitor/TV screen.
YES to save those changes or NO not to save them.
The MHT200 will then return to normal operation. Re-
fer to figure 13 on page 25.
Sub Crossover
The MHT200 incorporates a built-in Electronic Crossover.
The Crossover will redirect all of the audio frequencies be-
low the crossover frequency setting to the Subwoofer and
all the frequencies above the setting to the appropriate re-
maining Home Theater Loudspeakers. The default setting
for the SUB CROSSOVER frequency setting is 80 Hz,
which is the correct frequency for most Home Theater
Loudspeaker Systems. Refer to figure 26 and perform the
following steps to change the setting.
6. Using the Up or Down directional push-buttons
select SUB CROSSOVER from the On-Screen Menu,
followed by pressing the Left or Right directional
push-buttons to change the crossover frequency to the
desired setting. Select EXIT on the menu and the
SPEAKER SETUP Menu will reappear on the Moni-
tor/TV screen.
Note: The range of adjustment is from 40Hz to 140Hz in
10Hz increments.
7. Continue next to the DOLBY LFE LEVEL. If you do
not wish to perform DOLBY LFE LEVEL Adjustments
at this time, proceed to the next step.
8. Select EXIT from the SPEAKER SETUP Menu. The
MAIN SETUP Menu will reappear on the Monitor/TV
screen and select EXIT from the Menu. If you are sat-
isfied with the changes that you may have made, select
Figure 25
MENU: SUBWOOFER SETTINGS
1. MC BASS MODE Off
2. SUB CROSSOVER 80 Hz
3. DOLBY LFE LEVEL 0dB
4. SUB FILTER On
EXIT
Figure 26
MENU: SUBWOOFER SETTINGS
1. MC BASS MODE Off
2. SUB CROSSOVER 80 Hz
3. DOLBY LFE LEVEL 0dB
4. SUB FILTER On
EXIT
www.eskonline.nl
To Next Page
Loading...
