42
How to change Mode Setup
The MHT200 allows for modifications in how the Dolby
Digital Prologic II, DTS NEO:6 and the built-in Music 1
thru 4 Sound Processing Modes alter the sound. Refer to
figure 39.
1. Press and hold the Front Panel SETUP Push-button ap-
proximately three seconds to enter the Setup Mode.
The word SETUP will appear on the MHT200 Front
Panel Display and the MAIN SYSTEM SETUP Menu
will appear on the Monitor/TV screen. Refer to figure
12 on page 25.
2. Using the Up or Down directional push-buttons
select Mode Setup on the On-Screen Menu, followed
by the SELECT Push-button on the Remote Control.
PLII Panorama
This mode adds Surround Sound by spreading the sound
field of the front speakers to the left and right of the listen-
ing position. The effect can be switched On or Off.
3. Using the Up or Down directional push-buttons
select PLII PANORAMA from the On-Screen Menu,
followed by pressing the Left or Right directional
push-buttons to switch On the effect.
PLII Center Width
This mode takes some of the center channel signal and
adds it to the left and right front Loudspeakers, thus in-
creasing the width of the front sound field. The effect can
be varied with eight different settings ranging from mini-
mum to maximum.
4. Using the Up or Down directional push-buttons
select PLII C WIDTH on the On-Screen Menu, fol-
lowed by pressing the Left or Right directional
push-buttons to select the desired effect.
PLII Dimension
This mode allows for adjusting the balance between the
Front and Surround Sound Fields. The effect can be varied
with seven different settings ranging from -3 to +3.
5. Using the Up or Down directional push-buttons
select PLII DIMENSION on the On-Screen Menu, fol-
lowed by pressing the Left or Right directional
push-buttons to select the desired effect.
NEO:6 Center Image
This mode takes some of the center channel signal and
adds it to the left and right front Loudspeakers, thus in-
creasing the width of the front sound field. The effect can
be varied with six different settings ranging from minimum
to maximum.
Figure 39
MENU: MODE SETUP
1. PLII PANORAMA Off
2. PLII C WIDTH 3
3. PLII DIMENSION 0
4. NEO:6 C IMAGE 2
5. MUSIC MODE REVERB 2
EXIT
6. Using the Up or Down directional push-buttons
select PLII DIMENSION on the On-Screen Menu, fol-
lowed by pressing the Left or Right directional
push-buttons to select the desired effect.
Music Mode Reverberation
This mode adjusts the amount of reverberations added to
the Front Channels according to the reverberation in the
orginal recording. The effect can be varied with five differ-
ent settings ranging from dry (decreases front reverbera-
tions) to wet (increases front reverberations).
7. Using the Up or Down directional push-buttons
select MUSIC MODE REVERB on the On-Screen
Menu, followed by pressing the Left or Right di-
rectional push-buttons to select the desired effect.
8. Select EXIT on the menu and the MAIN SYSTEM
SETUP Menu will reappear on the Monitor/TV screen.
9. Continue next to the SYSTEM SETUP on the next
page. If you do not wish to perform SYSTEM SETUP
at this time, proceed to the next step.
10. Select EXIT from the MAIN SYSTEM SETUP Menu.
If you are satisfied with the changes that you may have
made, select YES to save those changes or NO not to
save them. The MHT200 will then return to normal op-
eration. Refer to figure 13 on page 25.
www.eskonline.nl
To Next Page
Loading...
