McIntosh MHT200

49
The INPUT Selector Switch together with the Zone B
Push-button allows making a recording from one program
source while listening to another. You can also listen
(monitor) to the recorded signal off the tape, a fraction of a
second later, during recording when a three head tape re-
corder is used. Refer to figure 50.
1. Press the ZONE B Push-button. The LED above the
button will illuminate and the Front Panel Alphanu-
meric Display will indicate Zone B OFF. Refer to fig-
ure 48.
2. Rotate the INPUT Selector Switch until the desired In-
put has been selected. Refer to figures 49 and 50.
Note: The INPUT Selector Switch will return to ZONE A
Input Selection about five seconds after the ZONE
B Push-button is pressed and the INPUT Selector is
no-longer being rotated.
3. Adjust the record level using the recorder’s volume
control.
How To Make A Recording
How to Operate the MHT200, con’t
Figure 49
Figure 48
4. To monitor the tape during the recording process, with
a three head tape recorder or playback the tape just re-
corded, turn the INPUT Selector Switch to select the
recorder used.
Note: The MHT200 RECORD OUTPUTS are not affected
by the VOLUME control. To listen to a different
program source while recording, turn the INPUT
Selector Switch to the desired source. The recording
process will not be affected and will continue.
Figure 50
www.eskonline.nl