McIntosh MHT200

46
depending on the settings of the individual TRIM Levels
and SURROUND Mode.
System Off
Normally, each Zone is turned On and Off individually by
pressing the Power Push-button on a Keypad or Remote
Control. If you desire to switch Off both Zones of the
McIntosh MHT200 A/V System Controller and connected
accessory source components, press the SYS OFF Push-
button on the Front Panel. Refer to figure 44.
Note: The Sys Off Push-button on a Keypad or Remote
Control may also be used to turn Off the entire system.
Zone B
First press the Zone B Push-button, then rotate the INPUT
Selector Switch for the desired source. The selected source
is available for Listening/Viewing in Zone B and at the
AUDIO RECORD OUTPUT jacks, for recording. If Zone
A is active, pressing the Zone B Push-button followed by
the STANDBY/ON Push-button will either Turn-On Zone
B or Turn-Off if Zone B is already active.
Notes: About five seconds after pressing the ZONE B Push-
button, the ZONE B Control Access will be switched Off
and the LED above the push-button will extinguish
unless a Front Panel Control or Push-button is engaged
after pressing the ZONE B Push-button. Refer to “How
to Operate Zone B” on page 54.
Tune 
If the optional TM1 Tuner Module is installed into the
MHT200, Preset AM/FM Radio Stations may be selected
by rotating the TRIM SELECT Control to the TUNE Posi-
tion and then press the TUNE Up or Down Push-but-
tons. Refer to page 64 for additional information.
Late Night
The LATE NIGHT Push-button turns a volume compres-
sion circuit on and off. This feature suppresses loud sounds
or music that might disturb neighbors or others not in the
immediate area of the Home Theater. Soft levels are also
raised slightly so they can still be heard at the reduced vol-
ume levels. This works only on a Dolby Digital Sound
Track with encoded data that supports the compression
function. Refer to figure 44.
Setup
Pressing the SETUP Push-button activates the MHT200
SETUP Mode for making changes to the Home Theater
System.
Front Panel Status
The eight Front Panel LEDs indicate the status of the Oper-
ating/Decoding Modes. Refer to figure 44.
Operating Mode Displays
A. The DOLBY DIGITAL Display will illuminate when
the input contains Dolby Digital Encoded Signals.
B. The PRO LOGIC II Display will illuminate when the
Surround Mode Selector is turned to CINEMA 1 or
MUSIC 1 and a 2-Channel Signal is present.
Figure 44
www.eskonline.nl