McIntosh MHT200

55
How to Operate the MHT200, con’t
3. If a McIntosh Disc Player is connected to the
MHT200, most operating functions can be performed
with the Keypad or Remote Control.
Note: By adding a McIntosh Remote Control Translator
to the MHT200, non McIntosh Source Devices,
such as a Satellite Receiver, can be remotely
controlled using a McIntosh Remote Control and
Keypads.
Controlling a Source Component from Zone B
To control a source component from the Keypad or Sensor
perform the following steps. Refer to figures 75 and/or 76.
1. Press the appropriate source push-button (e.g. CD) on
the Keypad or Remote Control and immediately press
the appropriate control push-button for the desired
function (e.g. the Next Push-button to play the
next selection from the disc).
Note: It is necessary to press the appropriate source
push-button before pressing the push-button for the
desired control function.
Figure 75
 
Figure 76
www.eskonline.nl