18
The code search begins with the code that is currently
stored.
While the search is running, the word SEARCHING
(along with the selected device type) is displayed.
If you miss the code, you can go back step by step with
the PROG– key.
12. When the device responds
accordingly each time a key is
pressed, press OK to save
the code. The
SUCCESS
confirmation message appears.
The remote control returns to normal operation.
Code identification
If you want to know which code is
saved on a particular mode key,
simply press this key. The selected
device type and device code
appear.
Univ-FB_MD 81302_UK.fm Seite 18 Montag, 7. August 2006 11:08 11
To Next Page
Loading...
