11
Backlight
The display's backlight comes on each time the button is
pressed. The backlight's factory setting is for 10 seconds.
You can switch off the backlight or extend it to 60 seconds.
Please note that the backlight uses up additional
battery life.
1. Keep the S (Setup) key pressed
down for approx. 3 seconds,
until CODE SETUP appears.
2. Press S again briefly to open
SYSTEM SETUP.
3. Confirm with OK. The
VOL/
MUTE SETUP
is displayed.
4. Use the arrows (press three
times) to select the
BACKLIGHT SETUP and
confirm with OK.
5. The current set time flashes
(factory setting is for 10
seconds). Use the arrows to
select the required time
span in five second intervals. -
In order to switch the backlight
off, select “00“ seconds.
Confirm with OK.
6. The confirmation message
SUCCESS appears and the
display returns to CODE SETUP.
Univ-FB_MD 81302_UK.fm Seite 11 Montag, 7. August 2006 11:08 11
To Next Page
Loading...
Need help?
General
