21
Set timer
The universal remote control has two timer functions:
a sleep-timer for the TV
(automatic switch off after 1 to
90 minutes);
"Zzz" appears in the display:
four additional times for
customisable commands (e.g.
switching to another
programme); the bell symbol
appears in the display.
TV sleep-timer
Set sleep-timer
1. Keep the S (Setup) key pressed
down for approx. 3 seconds,
until CODE SETUP appears.
2. Press S briefly twice more to
open
TIMER SETUP.
3. Press OK" The
TV SLEEP
SETUP
menu is displayed.
4. Press OK" The
TV SLEEP SET
display appears.
5. Press OK" The number of
minutes flash in the display.
6. Use the arrows to enter
the time after which the TV
device should switch itself off
automatically.
7. Press OK" The
SUCCESS
confirmation message appears
along with the TV timer symbol
"Zzz".
8. Lay the universal remote control down so that it is
pointing towards the device and is not obstructed.
Switch off sleep-timer
If a sleep-timer is on ("Zzz" appears in the display) TV SLEEP
CLEAR
appears in the display instead of TV SLEEP SET when
you perform the steps described above.
1. Perform steps 1 to 4 as
described above. The
TV
SLEEP CLEAR
display appears.
2. Press OK" The message
CONFIRM CLEAR is displayed.
3. Press OK" The
SUCCESS
confirmation message appears.
Univ-FB_MD 81302_UK.fm Seite 21 Montag, 7. August 2006 11:08 11
To Next Page
Loading...
