25
Program commands
To programme, proceed as follows:
1. Place the remote controls with the infrared diodes facing
each other spaced 15 to 50 mm apart on the table. The
infrared diodes must be pointing directly at each other.
2. Keep the S (Setup) key pressed
for approx. 3 seconds until
CODE SETUP appears.
3. Press S briefly three more times
to open the
LEARN SETUP
menu.
4. Press OK to open the learn
mode.
5. Confirm once again with OK.
6. Now select the mode key on
which the device of the original
remote control was
programmed.
7. The
LEARN KEY prompt
appears. Now select the key on
the universal remote control
that is to be assigned to the
original remote control function
(not: S or MACRO).
8. In the display you now see
LEARNING. Now select the key
on the universal remote control
whose function should be
assigned to the universal
remote control. Keep this key
pressed until either the
SUCCESS or LEARN ERROR
message appears.
9. The following query appears:
LEARN MORE?. If you want to
perform additional learn
functions, confirm with OK. The
LEARN KEY prompt appears
again. Proceed as described in
point 7.
If you want to end the learn function, press EXIT.
The remote control returns to normal operation.
Univ-FB_MD 81302_UK.fm Seite 25 Montag, 7. August 2006 11:08 11
To Next Page
Loading...
Need help?
General
