24
Learn function
You can manually save the functions of an original remote
control to your universal remote control. Commands are
saved to the mode key on which the device of the original
remote control was programmed.
The universal remote control can “learn” up to 150
commands.
Notes on learn function
Use new batteries for both remote controls.
If you start programming from the start
– especially after the first operation – delete all saved
commands first of all (see “Deleting commands for all
mode keys” on page 26).
Only one original remote control can be programmed on
each mode key.
If you would like to program an original remote control to
a mode key, first delete the commands on this mode key
(see “Deleting commands for only one mode key” on
page 26).
The LEARN ERROR message is displayed if the memory is
full. If this happens, delete saved commands.
Programming each key can take approx. 3 seconds. Do
not release the key to be learned before the SUCCESS or
LEARN ERROR message appears.
The following keys cannot be assigned to functions:
S (Setup), MACRO and all mode keys.
Some original remote controls (for DVD, video recorder,
SAT) can themselves be programmed with the device
codes of some TV brands to carry out basic TV set
functions (volume, mute, channel search).
Do not attempt to transfer the functions of an original
remote control that has been programmed with the code
of a different TV set to your universal remote control. This
could cause programming errors.
First try to program two or three commands and then test
them.
Before programming in your commands, first delete all
existing commands (see “Deleting commands for all
mode keys” on page 26).
Do not execute the learn function under a low-energy
lamp. Such lamps (e.g. fluorescent lamps) can contain
infrared light components that could influence the learn
function.
Univ-FB_MD 81302_UK.fm Seite 24 Montag, 7. August 2006 11:08 11
To Next Page
Loading...
Need help?
General
