23
10. Press OK. You are prompted to
make the first entry TIMER 1
KEY1
. Enter the first command.
In our example: Use the
number keys to select the
programme.
If no other input is needed, press OK or EXIT.
11. The
TIMER 1 KEY2 display
appears. Enter the second
command.
In our example: Press the
Record key.
12. The TIMER 1 KEY3 display
appears after the second
command.
In our example, press the
Record key again.
13. The
SUCCESS confirmation
message appears along with
the bell symbol after the third
command.
14. Lay the universal remote control down so that it is
pointing towards the device and is not obstructed.
You can cancel programming at any time by pressing EXIT.
Delete command timer
If a command timer is set (the bell symbol appears in the
display),
TIMER 1 CLEAR appears in the display instead of
TIMER 1 SET in the steps described above.
1. Perform steps 1 to 5 as
described above. The
TIMER 1
CLEAR
display appears.
2. Press OK" The message
CONFIRM CLEAR is displayed.
3. Press OK" The
SUCCESS
confirmation message appears.
Univ-FB_MD 81302_UK.fm Seite 23 Montag, 7. August 2006 11:08 11
To Next Page
Loading...
Need help?
General
