27
Macros
Using a macro, you can save a chain of commands, meaning
that several functions can be executed consecutively. You
can program three macros and store them on the number
keys 1, 2 and 3.
These three number keys have
the additional labels TV, VCR,
DVD, so that you can assign
macros accordingly.
Each macro can include up to ten key commands. A macro
can include different devices. In this way you could, for
example, switch on the TV set, the desired channel, the video
recorder and the recording function by simply pressing the
MACRO key and the selected number key 1, 2 or 3.
The S (Setup) and MACRO keys cannot be used for a macro.
If you would like to interrupt macro programming
prematurely, press S (Setup). In this case, the macro is not
saved.
Programming macros
1. Keep the S (Setup) key pressed
for approx. 3 seconds, until
CODE SETUP appears.
2. Press S briefly four more times
to open the
MACRO SETUP
menu.
3. Press OK to open the
MACRO
SET
mode.
4. Confirm once again with OK.
5. Now select the number key 1,
2 or 3 where the macro is to be
saved.
6. The query
MACRO 1 MODE?
appears. (The number
corresponds to the previously
selected number key.) Press a
mode key for the device where
the command is to start.
7. The input query
MACRO 1 KEY?
appears with the step number
(02 for the second step). Now
carry out the function that you would like to save as a
macro. You can press up to 9 other keys and you can
also change devices via the mode keys.
8. When the series of steps is finished, press the MACRO
key to save the macro.
The macro is saved automatically after step 10.
9. The
SUCCESS confirmation
message appears.
Univ-FB_MD 81302_UK.fm Seite 27 Montag, 7. August 2006 11:08 11
To Next Page
Loading...
Need help?
General
