PCF Pro User Manual
DOC01851 Page 33 of 74
Power Up
Turn on the power to the machine using the
isolation switch on the wall.
When the machine is turned on, it conducts a
Power-On Self-Test (POST) to ensure the
machine is ready for use.
This process takes a few seconds to configure
the machine and check the basic operation of
the control system, memory and sensor
interfaces.
Before the carrier lift system can be used, it
must zero its position sensor. If the machine
was powered off and the carrier lift was not
fully open or closed, then the display will show:
.
Press and hold until the carrier lift is fully
open.
Authorisation code
This is an optional feature, which can be
enabled by a service engineer. When enabled,
the user is required to enter a four-digit PIN
number to unlock the user control panel. A
valid PIN entry identifies the user and their
operator number is shown on the cycle
printout. There are 80 operator numbers each
with a unique PIN number, see Appendix 6-7
for details.
To Next Page
Loading...
