PCF Pro User Manual
DOC01851 Page 46 of 74
Cooling
On completion of the last cleaning stage, the
inside of the machine will be hot. To reduce
the water vapour and temperature, cold water
is cascaded down the back wall of the tank
and into the drain a pre-defined time.
Note: this water does not come into contact
with the load.
Finally, all water in the tank is drained.
Drying
To aid the drying of cannulated instruments
and to remove excess water from manifolds
and pipework, compressed air is alternately
blown through the irrigation ports and spray
arms. This minimises spillage when the
baskets are removed from the machine.
Cycle Complete
When the cycle is complete, a sound is played
and the LED Edge flashes green.
Confirm cycle record is present and indicates
the cycle has completed with no errors.
Unload
The unload sequence is optimised for hands
free operation, where the Load foot pedal is
used to step through an automated sequence:
1. Press and hold the Load foot pedal
until the carrier lift indexes up to the
bottom basket and stops
2. Remove the top basket from the
machine (see section 3-7-1)
3. Press and hold the Load foot pedal
until the carrier lift indexes up to the
next level and stops
4. Remove the middle basket from the
machine (see section 3-7-1)
5. Press and hold the Load foot pedal
until the carrier lift indexes up to the
next level and stops
6. Remove the bottom basket from the
machine (see section 3-7-1)
If any instruments became
detached from the Medisafe
connection tubing during
processing, they should be
reprocessed ensuring that the
Luer connection is firmly seated.
7. The machine is now ready for the next
cycle
Note: the touch screen controls may be used
to bypass the automated sequence (see
section 3-7-6)
To Next Page
Loading...
