13
4) Press the SAVE HOTKEY to accept changes.
Further changes can be made in the menu SETUP options section 10.5
On completion of the initialisation the following warning screen is displayed when the PAT tester is switched on.
UK configured PAT400 instruments Non- UK configured PAT400 instruments
NOTE: This screen is not displayed if the PAT tester is re-started within five minutes of being un-plugged,
or when the PAT tester restarts from the same screen as before.
5) Press OK to confirm you have read and understood these warnings. The instrument will display the following HOME screen
when all initial tests pass.
To Next Page
Loading...
