76
(UP)
15: Frequency decrease command
(DN)
16: External fault normally open input
17: External fault normally closed input
18: External interrupt normally open
contact input
19: External interrupt normally closed
contact input
20: Reference frequency source
switching command
21: Reserved
22: External reset (RESET) input
23: Coast to stop input (FRS)
24: Acceleration/deceleration disable
command
25: Stop DC braking input command
26: Simple PLC pause command
27: Reserved
28: Clearing the PLC stop memory
29: PID disabled
30: PID closed loop soft-start disabled
31: PID integral retention
32: PID integral clearing
33: Switching PID adjustment
34: Main reference frequency source
selection 1
35: Main reference frequency source
selection 2
36: Main reference frequency source
selection 3
37: Switching main reference
frequency to AI
38: Command source selection 1
39: Command source selection 2
40: Switching command to terminal
41: FWD disabled
42: REV disabled
43: Drive running disabled
44: External stop command (it is valid
for all the control modes, the device
will be stopped in accordance with the
current stop mode)
45: Auxiliary reference frequency reset
46: Pre-magnetizing command
terminal (reserved)
47~54:Reserved
To Next Page
Loading...