Melco EMT16X - Head Timing Keypad Functions

26 of 289
Head Timing Keypad Functions
When the Head Timing tab is open in the software, several special keypad functions are available. These
keypad functions are only available when the Head Timing tab is open. The following table describes
these functions.
+
Go To Head Up Position
Adjustment Key + Up Arrow
+
Go To Bottom Center Position
Adjustment Key + Down Arrow
+
Rotate Hook Forward
(Approximately 20° increments)
Adjustment Key + Right Arrow
+
Rotate Z-Axis to 120°
(Move needle to just above the needle plate)
Adjustment Key + Left Arrow
+
Rotate Hook Forward
(Approximately 1° increments)
Adjustment Key + Up Arrow
+
Rotate Hook Forward
(Approximately 1° increments)
Adjustment Key + Down Arrow
+
Micro-step Rotate Hook Forward
(Approximately 0.1° increments)
Trace Key + Down Arrow
+
Micro-step Rotate Hook Backward
(Approximately 0.1° increments)
Trace Key + Down Arrow
+
Shift Needle Case Right
(Used for Color Calibration)
Trace Key + Right Arrow
+
Shift Needle Case Left
(Used for Color Calibration)
Trace Key + Left Arrow
Table of Contents
Critical Measurements