95 of 289
X/Y Home Adjustment
Setting X/Y home requires the use of the X/Y Home Fixture (PN: 30873). The use of this xture is strongly
recommended as it provides for consistent accuracy in the home settings.
Home Adjustment Procedures:
1. Turn the machine ON.
2. Engage the emergency stop by pushing the e-stop button in.
•
CAUTION!! Use extreme care not to drop metallic objects, tools, or other conductive material
on the Main PCB when you have the base cover removed. If you drop such objects on the Main
PCB, it can severely damage the electronics which will be very expensive to repair.
3. Remove cover for the main PCB.
a. Remove the 4 screw(s) that hold the main PCB cover in place.
b. Remove the PCB cover.
Figure 1 - X- and Y-Home LEDs
4. Being careful not to touch the main PCB while it is powered up, locate the X and Y-Home LEDs
(LEDs are located below the labels, but remain in the same order). You will need to observe
whether these LEDs are on or off while setting home. Home for these LEDs is set correctly right at
the point where these LEDs are brightly illuminated (not dim or off).
To Next Page
Loading...
