90 of 289
Centering The Needle Plate
1. Center the needle plate as best you can by feel and by eye.
2. Lower the needle to its bottom most rotation. This can be done manually by pressing the e-stop
and rotating the z-shaft to control the decent of the needle.
3. With the needle lowered, loosen the screws securing the needle plate, and center the hole in the
needle plate around the needle.
4. Tighten the screws securing the needle plate.
5. Raise the needle back up by releasing the E-stop button. Turn the button a quarter turn in the
direction of the arrows and release..
.
To Next Page
Loading...
