52 of 289
Monthly Maintenance
X-Drive Rails
•
WARNING!! If you currently have a hoop or clamping system on the machine, please remove it.
Failure to fully remove a clamping system can result in damage to the machine.
1. Move the x-beam all the way forward and all the way to the left using the hoop and the arrow
keys on the keypad.
2. Remove the end cap cover on the right side of the x-beam as shown in the image.
3. Wipe any lint, dust, and old grease from the front and back steel rails inside the x-beam as shown
in the image.
4. Using a clean piece of cloth, apply a thin lm of HP grease to the front and back steel rails inside
the x-beam as shown in the image.
5. Replace the end cap cover that was previously removed.
To Next Page
Loading...
