65 of 289
37. Using the image as a guide, apply three (3) small dots of EMB Polymer grease to the side of the
hub. Do this for each side of the thread feed roller.
38. Carefully reinstall the thread feed roller. The gear side of the roller should fall to the left. Align the
roller with the slot and gently press forward and down until the roller snaps into place.
Take care to clean up any grease that may transfer to the front of the slot.
39. Reinstall the front covers by holding them at the bottom and tilting them up. Insert the top of the
cover into the slot at the top of thread feeder assembly. You will probably feel a slight click as it
locks into place.
40. Rock the cover forward and down until it snaps into place. Keep in mind that the covers overlap
and will reinstall easiest starting with needle 1.
41. Next you need to remove the pinch rollers. This is easiest if you leave the thread feed levers up.
Then steady the lever with one hand and pull the roller to the right with the other. This will release
it from the hub.
To Next Page
Loading...
