5. Check the display for the E‑stop fault due to lanyard activation has
cleared and there are no active faults or conditions that may cause active
faults.
6. Check the safety and positioning of passengers before operating the
outboard.
7. Twist the tiller handle grip into forward or reverse gear position.
NOTE:Throttle direction configuration is dependent on outboard setup. Refer
to
Outboard Settings ‑ Tiller Models
.
Outboard Settings ‑ Tiller Models
THROTTLE DIRECTION AND UNITS OF MEASURE SETUP
1. Press and hold the menu button for two seconds.
OPERATION
90 eng
To Next Page
Loading...
