3.
Turn te key to the ON position.
Key in ON position
4. Check the display that there are no active faults or conditions that may
cause active faults.
5. Check the safety and positioning of passengers before operating the
outboard.
6. Move the remote control lever into forward or reverse position to move the
boat. Refer to Using and Changing Directional Controls.
Operating the outboard ‑ Tiller Handle Models
Before starting, Refer to the Prestarting Check List and Prestarting
Instructions
1. Verify the tiller handle grip is in the neutral position (lines are aligned).
a - Line on the tiller housing
b - Line on the tiller control grip
2. Press the power button on the display to power up the outboard.
3. Remove the lanyard from the stop switch on the tiller handle.
4. Install the lanyard to the stop switch and connect it to the operator.
OPERATION
eng 89
To Next Page
Loading...
Need help?
General
