Battery Connector
IMPORTANT:To prevent damage to the battery connectors of the outboard,
use the weather cap to cover terminals when the battery is removed from the
outboard.
Battery Charger Selection
The 7.5e Avator outboard comes with a 110‑watt battery charger. The 110‑watt
charger has an estimated charge time of nine hours on a depleted 1 kWh
battery.
An optional 230‑watt battery charger is available for faster charging times. The
230‑watt charger is estimated to charge a depleted 1 kWh battery in four hours.
Estimated charge times are calculated based on charging a depleted battery to
fully charged, in ambient temperature range between 0‑30 °C (32‑89.6 °F).
Charging the Battery
IMPORTANT:Do not charge the battery near flammable liquids or materials,
near direct or indirect heat sources, or in direct sunlight.
IMPORTANT:While charging, if the battery core temperature reaches 45 °C
(113°F) the battery management system (BMS) will discontinue charging the
battery until the battery temperature is reduced. Allow the battery to cool down
before charging the battery. Battery charging may be delayed, but will resume
charging when the battery temperature has cooled down.
1. Power off the outboard.
2.
Remove the battery from the outboard. Refer to Battery Removal.
3. Install the weather cap over the battery connector of the outboard.
BATTERY
eng 25
To Next Page
Loading...
Need help?
General
