The start‑in‑neutral‑protection device is designed to prevent the outboard from
activating if the display is powered up on the tiller models. However, before
activating the power up sequence check to make sure that the remote control
or the tiller control grip iz in the neutral position.
Lanyard Stop Switch
The purpose of a lanyard stop switch is to stop the outboard when the operator
moves far enough away from the operator's position (as in accidental ejection
from the operator's position) to activate the switch. Tiller handle outboards and
panel mounted lanyard switches provide similar functionality and will stop or
prevent propeller rotation as soon as the lanyard is displaced from its installed
location.
Remote control models only ‑ the lanyard stop switch can be installed as an
accessory ‑ generally on the dashboard or side adjacent to the operator's
position.
A decal near the lanyard stop switch is a visual reminder for the operator to
attach the lanyard to their personal flotation device (PFD) or wrist.
NOTE:Wireless Man Overboard Protection (MOB) devices are not considered
a substitute for the protection offered by the lanyard stop switch.
GENERAL INFORMATION
2 eng
To Next Page
Loading...
Need help?
General
